Microphone adapter kit with
sleeve for SM
transmitter. Kit includes instructions, sleeve, tubing and
TA5F connector, plus two each 1.5 K Ohm and 3.3 k Ohm resistors.
Replacement windscreen for
M121S and the
M131S hand held mics.
35690
Strain Relief For all Lectrosonics
Microphone Systems.
MCATA5M2-WP
Adapts 2-wire microphones with TA5F connectors
wired for Lectrosonics transmitters to MM Series miniature
transmitters.
MCATA5M3-WP
Adapts 3-wire microphones with TA5F connectors
wired for Lectrosonics transmitters to MM Series miniature
transmitters.
MCAXLRLINE-WP
Adapts XLR Line Level microphones
to MM Series miniature transmitters. Offers -20 dB attenuation
and includes built in isolation capacitor to block DC voltage
from transmitter; 37” long.
MCAXLRMIC-WP
Adapts XLR microphones to MM
Series miniature transmitters. Includes built in isolation
capacitor to block DC voltage from transmitter, 37”
long.
MCA-TA5PAD
Two-wire, -10 dB adapter for
two wire microphones
using TA5F connectors.
MCA-TPOWER
Used with UH200D, UH400 and
UH400A
plug-on transmitters with T-powered microphones. This adapter
converts the UH400's 18 Volt phantom power setting to a
TPOWER compatible circuit. It also protects the T-power
mic against the 48V phantom power setting in the transmitter
while allowing normal operation.
Note
This is not a “universal” adapter and is intended
for use with the Lectrosonics UH200D, UH400 and UH400A
transmitters only. Both the UH200D and UH400 have been
replaced by the UH400A.
MCA5X
Converts
5-pin plugs wired for Lectrosonics belt-pack transmitters
to the XLR jack on Lectro plug-on transmitters. Zener diode
protects mic from greater than 6V phantom power on XLR jack.
Size: 2 inches long by .75 inches diameter).
